3M Scotch-Weld PUR Easy 250 Preheater Manuel D'utilisation page 7

WARNING
!
Do not use an unapproved extension
cord with the preheater. Use of an
improper extension cord may cause
electrical shock. Use an extension
cord which complies with NEC
requirements and state and local
codes and other requirements.
Caution
!
Avoid contact with top surface and
metal heating chambers of preheater
during use and hot adhesive cartridges
and adhesive. May cause burns.
IMPORTANT: Wear heat resistant
gloves and safety glasses when using.
WARNING
!
Use only 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
Adhesive Cartridges. Use with any
other material may cause hazardous
conditions.
©3M 2014
9. Tap the punch handle using a hammer, mallet or similar instrument until the front
aluminum seal of the cartridge has been pierced.
10. Select and install a disposable nozzle (A) provided with the 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 20 or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive onto the cartridge by turning the nozzle clockwise until the
nozzle base is tight or flush with the cartridge using the supplied plastic wrench
(B) to aid tightening.
11. Insert adhesive cartridge complete with disposable nozzle into the applicator.
See the 3M™ Scotchweld™ Polyurethane Reactive (PUR) Easy 250 Adhesive
Applicator's User Manual for adhesive loading and operating instructions.
12. When finished using the preheater, push the on-off switch to the "off" position.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Preheater User's Manual
5