Instructions For Use - 3M Scotch-Weld PUR Easy 250 Preheater Manuel D'utilisation

Instructions for Use

WARNING
!
Do not use an unapproved
extension cord with the
preheater. Use of an improper
extension cord may cause
electrical shock. Use an
extension cord which complies
with NEC requirements and
state and local codes and other
requirements.
Caution
!
Use only with 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
Adhesive Cartridges. Use with any
other materials may cause hazardous
conditions.
IMPORTANT: Wear heat
resistant gloves and safety
glasses when using.
WARNING
!
Use only 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
Adhesive Cartridges. Use with any
other material may cause hazardous
conditions.
©3M 2014
1. Remove the 3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive
Preheater from its shipping container and inspect for obvious damage. If damaged, do
not use and immediately contact your local 3M representative.
2. Insert the power cord into the receptacle on the back, lower side of the preheater.
Make sure the ground pin on the preheater is aligned with the ground receptacle on
the cord.
3. Plug the preheater into a grounded receptacle.
4. a. Depress upper portion of ON-OFF switch for high temperature heating of 3M™
Scotch-Weld™ Polyurethane Reactive and 3M™ Scotch-Weld™ Polyurethane Reactive
(PUR) Easy 250 adhesives.
4. b. Depress lower portion of ON-OFF switch for low temperature heating of 3M™
Scotch-Weld™ Polyurethane Reactive (PUR) Easy adhesives.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Preheater User's Manual
3