Side Discharge Chute - Remington K Serie Notice D'utilisation

5. Perform the proceeding steps to
complete handle assembly:
a. Pull upward on the handle until
holes in lower handle (shown in
Figure 2-3 deck cutaway) line up
with holes in handle bracket.
See Figure 2-4.
b
a
b
(a)
Figure 2-4
NOTE: When pulling upward on handle,
make sure to not pull handle all the way
out.
b. Insert the T-bolts (a) removed
in Step 4 through the handle
brackets and lower handle and
tighten securely to secure the
handle in place. See Figure 2-4.
c. Reattach wing knobs (a) and
carriage bolts (b) removed in
Step 2 into lower holes of handle
as shown in Figure 2-5.
c
(b)
c
(b)
(a)
Figure 2-5
6. The rope guide is attached to the right
side of the upper handle. Loosen the
wing knob (a) which secures the rope
guide. See Figure 2-6.
b
(a)
(a)
c
Figure 2-6
a. Hold blade control against upper
handle.
b. Slowly pull starter rope handle
from engine and slip starter rope
into the rope guide.
c. Tighten rope guide wing
knob (a).
d. Use cable ties to secure cables to
lower handle.
(a)
NOTE: On select units, use the two cable
clips provided to secure blade control
and drive cables to lower handle as
shown in Figure 2-7.
Figure 2-7
IMPORTANT: To reduce wear and allow
for proper operation, make sure to leave
some slack in the upper portion of the
cables.
Grass Catcher (If Equipped)
(a)
1. Follow steps below to assemble the
grass catcher (if needed). Make certain
bag is turned right side out before
assembling (warning label will be on the
outside). See Figure 2-8.
a. Place bag over frame so that
its black plastic side is at the
bottom.
b. Slip plastic channel of grass bag
over hooks on the frame.
B
a
d
Figure 2-8
2. Follow steps below to attach grass
catcher. See Figure 2-9.
a. Lift mower rear discharge door.
b. Place grass catcher into the slots
in the handle brackets. Let go of
discharge door so that it rests on
the grass catcher.
Figure 2-9
To remove grass catcher, lift mower rear
discharge door. Lift grass catcher up and off
the slots in the handle brackets. Release mower
rear discharge door to allow it to close rear
opening of mower.

Side Discharge Chute

(If Equipped)
Your mower may be shipped as a mulcher.
To convert to side discharge, make sure grass
catcher (if equipped) is OFF the unit and
mower rear discharge door (if equipped) is
closed.
1. On the side of the mower, lift the mulch
plug. See Figure 2-10.
2. Slide two hooks of side discharge
chute under hinge pin on mulch plug
assembly. Lower the mulch plug.
Mulch Plug
Figure 2-10
NOTE: Do not remove side mulch plug
at any time.
A
S 2 — A
ection
B
A
B
1
2
& S -U 7
SSembly et p