Teesa TSA2012 Manuel D'utilisation page 22

22
escape through the soleplate).
2. Plug the device to power mains.
3. Turn temperature dial to your desired setting, which is
depended on the fabric of garment, and temperature indicator
will illuminate while heating up. You can also refer to chart
below. Once it reaches the temperature, the indicator will be
extinguished, which indicates the soleplate has achieved the
selected temperature.
Caution:
EN
Note: temperatures provided in this chart are for reference only,
and may vary in your device for various external reasons.
4. Set the steam switch to
steam function) and begin ironing.
5. Keep the iron moving at all times!
6. ALWAYS disconnect the iron from the mains supply when
finished. Do not leave the iron connected to power supply
after you're done with ironing! Carefully pour off any remaining
water (risk of scalding) and leave the iron to cool off in vertical
position.
Note: When the ironing is finished, and during breaks in ironing,
place the iron in its upright position.
Use this function for steam ironing. User can either turn on or off
the steam output. Wait until the iron is heated and change the
steam switch position to
The iron will automatically start producing steam (provided the
iron has reached required temperature).
NOTE: if selected temperatures are too low and do not support steam
function (see chart) there will occur dripping from the soleplate.
• Do not touch hot soleplate at any time before cooling
down!
• Don't emit the steam directly on people or animals!
Setting
Continuous steam control
Fabric Temperature
Nylon 60°C - 105°C
Silk 105°C - 145°C
Wool 145°C - 175°C
Cotton 175°C - 200°C
Linen 200°C - 220°C
position (if you want to use the
to use continuous steam function.
Owner's manual
Variable
steam
×
×
√
√
√