Reversing The Door Swing - Summit FFBF279SSBI Mode D'emploi

NOTE: To allow the doors to self-close, tilt the appliance backwards by
10-15mm (1/3" – 2/3").

Reversing the Door Swing

CAUTION: When reversing the door, the appliance must not be
connected to the power source. Ensure the appliance is not
plugged in before reversing the door.
The side at which the door opens can be changes from the right side (as supplied) to the left side, if
desired.
NOTE: You may have to lay the refrigerator on its back in order to gain access to the base. Be
careful to rest it on soft foam packaging or a similar material to avoid damaging the back of
the refrigerator.
To reverse the direction of the door swing, follow these steps:
1. Stand the refrigerator upright. Open the door and remove all
door racks, and close the door.
NOTE: Slightly squeeze the door rack from the two sides toward
the center and inside of the rack, then move it upward to
remove from the door.
2. Remove the right upper hinge cover from the top of the
cabinet. Remove the 3 screws, which are used for fixing the
right upper hinge part (see the picture below) and take down the hinge parts.
3. Remove the screw cover from the left-front corner of the cabinet with a flat-head screwdriver,
and install the screw cover-right to the right front corner. Put the upper hinge cover (right) and
upper hinge part (right) into the plastic bag provided with your appliance.
8