Reversing The Door Swing - Summit ACCUCOLD ACF48W Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

prong wall outlets to minimize the possibility of electrical shock.
• Do not under any circumstances cut or remove the third ground prong
from the power cord supplied.
• This freezer requires a standard 115Volts AC ~ 60Hz electrical outlet with
three-prong grounded receptacle.
• To prevent accidental injury, the cord should be secured behind the
appliance and not left exposed or dangling.
• Never unplug the freezer by pulling the power cord. Always grip the plug
firmly and pull straight out from the receptacle.
• Do not use an extension cord with this appliance. If the power cord is too
short, have a qualified electrician or service technician install an outlet
near the appliance.

Reversing the Door Swing

This freezer has the capability of the door opening from either the left or right
side. The unit is delivered to you with the door opening from the left side.
Should you desire to reverse the opening direction, follow the directions below.
If you have a problem, call SUMMIT Customer Service at 1-800-932-4267.
1. Take off the upper hinge cover from the door and remove the screws that
hold the top hinge.
2. Lift the hinge straight up to free the hinge pin from the socket in the top of
the door.
3. Lift the door up and away to free its bottom socket from the hinge pin.
4. Remove the screws to the bottom hinge.
5. Remove the decorative caps from the opposite side and plug the holes
from the original side with the decorative caps.
6. Remove the two screws from the front of the kick plate.
7. Move the bottom hinge to the left side and tighten it with two screws. Use
any lock washers or nuts if they were included in the original installation.
8. Replace door onto the hinge pin on the bottom hinge. Place top hinge pin
into door. Insert screws into top hinge and tighten.
9. Reinstall the kick plate and tighten the two screws.
If you notice the door is not hanging straight, loosen the top hinge, adjust the
door until it is level and tighten the screws.
6

Publicité

Chapitres

Table des Matières
loading

Table des Matières