Replacing the LED Light
The LED light should only be replaced by a competent person. If the LED light is damaged, contact
the customer service helpline for assistance.
To replace the LED light, follow these steps:
1. Unplug the appliance.
2. Remove the light cover by pushing up and out.
3. Hold the LED cover with one hand and pull it with the other hand while pressing the connector
latch.
4. Replace the LED light and snap it correctly in place.
If you experience a problem with your appliance or are concerned that the appliance is not functioning
correctly,
you can carry out some easy checks before calling for
Problem
The appliance is not
working properly.
Odors emitting from the
compartments.
The appliance is making
too much noise.
TROUBLESHOOTING
Possible Cause and Solution
Check whether the power cord is plugged into the power outlet properly.
Check whether the "Power" function is on by pressing the POWER button
for one second.
Check the fuse or circuit of your power supply, and replace it, if necessary.
It is normal that the freezer is not operating during the defrost cycle, or for
a short time after the appliance is switched on to protect the compressor.
The interior may need to be cleaned.
Some food, containers, or wrapping may cause odors.
The sounds below are normal:
The compressor operating noises.
Air movement noise from the small fan motor in the freezer
compartment or other compartments.
Gurgling sounds similar to water boiling.
Popping noises made during automatic defrosting.
Clicking noise before compressor starts.
Other unusual noises may be caused by the following reasons and may
need to be checked:
The cabinet is not level.
The back of the appliance touches the wall.
Bottles or containers have fallen or are rolling.
It is normal to frequently hear the sound of the motor, and it will run more
in the following circumstances:
The temperature is set colder than necessary
A large quantity of warm food has recently been stored in the appliance.
service,
14
please see below.