Intended Use; Service/Maintenance - Storch AirClean 4200 PRO Mode D'emploi

Intended use

The extractor fan is particularly suitable for extracting and
filtering fine airborne dust particles and spray mist to improve the condition of the ambient air during renovation and
restoration procedures, to aid building drying processes and to aerate and ventilate rooms.
Extraction and filtering of dust and spray mist
The dust bag is mounted at the exhaust side of the extractor fan to absorb the airborne dust particles and spray mist
generated during renovation and restoration procedures. The exhaust side is identified by the arrow on the device. The
dust bag is attached to the exhaust side with a clamp. The dust bag is 3 metres long. It should be ensured that it is able
to fully expand to guarantee optimal filtration of the dust, dirt and spray mist particles. Optimal extraction for largescale
renovation and restoration procedures can be achieved if the windows in the room remain closed and the suction port of
the AirClean unit is placed in the entrance door. Seal the door frame above and beside the device with film. Doing this
will generate negative pressure in the room.
Using the reusable filter bag (included)
Please make sure the filter bag is cleaned on a regular basis (shake / wash and dry). A clogged filter will reduce the suc-
tion power of the AirRClean unit. For example, directly next to the radiator when spray painting radiators, or in the door
frame when sanding ceilings.
You can read off the elapsed operating hours from the operating hours
counter.
Use for drying buildings
When drying builds deploy at least one extraction fan per room. Make sure that the outlet side faces the wet surfaces.
Use of the extraction fan increases evaporation in the room.
This increases the humidity and drying becomes slower. For this reason, we recommend additionally deploying a building
dryer (air dehumidifier), e. g. the STORCH HighDry 300 Building Dryer. (Art. No. 61 53 00). To accelerate drying, seal off
the area to be dried from the rest of the building. For best possible dehumidifying performance, the ambient temperature
should be between 20° C and 27° C.
Operation
Always use an earthed power supply at 230 V / 50Hz to operate the extraction fan. If you will be using the extraction
fan for extracting and filtering dust and spray mist, make sure you use the clamp to attach the dust bag included with the
device to the extraction side (direction of arrow). Switch on the device and check that it is operating properly. Do not move
or transport the extraction fan during operations. Do not reach into, or insert objects into, the device.

Service/Maintenance

Caution:
Always unplug the power plug before commencing servicing or maintenance work.
Visual check: Check the power cable, housing, ventilator covers and motor housing regularly for signs of damage.
Clean the air intake: Clean the air intake: Remove any soiling that has built up at the air intake. Use compressed air to
remove fibrous material, dust and fan blades from the fan wheel, motor and side covers. Never clean the extraction fan
with a water jet or a pressure washer.
Motor bearings: The bearings on the device are permanently lubricated. Do not oil or grease.
27 Translation of the original instruction