Operation - Lippert Components Hitch-IT BikeBase/BikeWing Combo Unit Manuel D'installation Et Du Propriétaire

Operation

NOTE: For mounting two bicycles, the best technique is to
position the bicycles front-to-back and back-to-front with
the bicycle chain rings to the outside.
1. Hang one bicycle on the inside of the BikeWing so the
top of each wheel is supported by a cradle.
2. Secure by the bicycle tensioning each rubber strap over
the top of each tire and engaging a strap hole with the end of
the cradle.
3. Using the same fastening technique as in step 2, utilize
one SwayStop pin to secure one wheel below the frame
where the wheel crosses the wing.
4. If installed, use the additional SwayStop pin to secure
both wheels of the bicycle to the BikeWing.
5. Repeat steps 2-4 for a second bicycle on the other side
of the BikeWing.
lci1.com 574-537-8900
Hitch-IT
BikeWing
Installation and Owner's Manual
(For Aftermarket Applications)
Notes
7
CCD-0002231
BikeBase
™
Combo Unit
™
/
™
Rev: 01.03.19