Bikewing To Bikebase Options - Lippert Components Hitch-IT BikeBase/BikeWing Combo Unit Manuel D'installation Et Du Propriétaire

BikeWing to BikeBase Options

NOTE: The Stinger or the Y-shaped base of the BikeWing
can be inserted into the BikeBase receiver tube, depending
on wing height concerns and other clearance or height
issues.
1. Attach the BikeWing Stinger (Fig.2) or the BikeWing
Y-shaped base (Fig.3) to the receiver tube of the BikeBase
with a NoMotion pin and washers. Install the split lock
washer first and then the flat washer onto the NoMotion
pin.
NOTE: The flat washer is placed against the BikeBase
surface, while the split lock washer is in contact with the
bolt head.
2. Securely tighten the NoMotion pin with a
wrench until the split lock washer is fully compressed.
MAKE SURE THE NOMOTION PIN IS PROPERLY
TIGHTENED BEFORE INSTALLING ADDITIONAL
JACK-IT COMPONENTS AND CARGO AND BEFORE
BEGINNING TRANSIT.
3. Insert the hairpin cotter pin through the hole at the end
of the NoMotion pin.
lci1.com
3/4
" socket
574-537-8900
Hitch-IT
BikeWing
Installation and Owner's Manual
(For Aftermarket Applications)
flat
washer
split lock
washer
NoMotion
pin
Fig.2
hairpin
cotter pin
BikeBase
Fig.3
5
CCD-0002231
BikeBase
™
Combo Unit
™
BikeWing
Stinger
hairpin
cotter
BikeBase
BikeWing
Y-shaped base
flat washer
split lock
washer
NoMotion
pin
/
™
pin
Rev: 01.03.19