Publicité
Les langues disponibles
Les langues disponibles
Manual Tongue Jack Operation
If 12V DC power is unavailable to operate the tongue jack
or if utilizing a manual tongue jack, manual operation of the
jack is possible without removing the PowerTower.
1. If installed, detach the Stinger from the PowerTower
(Fig.2) by removing the threaded NoMotion pin, washers
and hairpin cotter pin. (Tongue jack removed for clarity.)
2. Remove the plug located on top of the tongue jack
(Fig.3) to expose the manual drive shaft. (PowerTower
removed for clarity.)
3. Utilizing the opening in the top of the PowerTower
(Fig.4), insert the appropriately-sized ratchet, extension
3/4
and
" socket or tongue jack crank handle to turn the drive
shaft and manually raise or lower the jack.
Jack-It
Stinger
split lock washer
NoMotion
pin
flat washer
Fig.2
lci1.com
574-537-8900
Jack-IT
Installation and Owner's Manual
(For Aftermarket Applications)
plug on tongue jack
Fig.3
Fig.4
Manual information may be distributed as a complete
document only, unless Lippert Components provides
explicit consent to distribute individual parts.
All manual information is subject to change without
notice. Revised editions will be available for free
download at lci1.com. Manual information is considered
factual until made obsolete by a revised version.
Please recycle all obsolete materials and contact
Lippert Components with concerns or questions.
4
CCD-0002237
PowerTower
®
end of crank handle
PowerTower opening
™
Rev: 10.25.18
Publicité
Chapitres
