Publicité
Les langues disponibles
Les langues disponibles
THE TRAILER MUST BE SUPPORTED PER THE
MANUFACTURER'S RECOMMENDATIONS BEFORE
WORKING UNDERNEATH. FAILURE TO DO SO MAY
RESULT IN DEATH, SERIOUS PERSONAL INJURY OR
SEVERE PRODUCT OR PROPERTY DAMAGE.
Installation
1. Support framework in accordance with the
manufacturer's recommendations.
2. If installed, remove the tongue jack from the coupler.
3. Position the PowerTower (Fig.1) on the coupler.
4. Place the tongue jack in the PowerTower (Fig.1) and
slide tongue jack through the hole in the coupler.
5. Align the three holes in the PowerTower base and
tongue jack base mounting plates with the holes in the
coupler.
6. Place a split lock washer and a flat washer on a
and insert the bolt in one of the holes in the coupler (Fig.1).
7. Use a socket wrench with a
the bolt and compress the lock washer.
8. Repeat steps 6 and 7 with the other two bolts to secure
the PowerTower and tongue jack to the coupler.
Attach BikeWing to PowerTower
To utilize the bicycle rack system, the Stinger
the BikeWing
can be attached directly to the top of the
™
PowerTower. The BikeWing component is sold separately.
Complete installation instructions for the Jack-IT bicycle
rack are detailed in a separate manual on the Customer
Service section of LCI's website. See
www.lci1.com/bike-racks/support-jack-it-bike-racks and
then select Jack-IT Aftermarket Manual from the listed
documents.
lci1.com
9/16
" socket to firmly tighten
end of
™
Jack-IT
or go to http://
574-537-8900
Jack-IT
Installation and Owner's Manual
(For Aftermarket Applications)
3/8
" bolt
3
PowerTower
®
Stinger of
BikeWing
PowerTower
tongue jack
3/8
" bolt
split
lock
washer
flat
washer
coupler
Fig.1
CCD-0002237
™
Rev: 10.25.18
Publicité
Chapitres
