Chamberlain LiftMaster PANNEAU DE COMMANDE MyQ 888LM Mode D'emploi page 2

PROGRAMMING
REMOTE CONTROL 1. Press the MyQ
2. Press the button on the remote control
3. The garage door opener lights will flash
MyQ ® ENABLED
ACCESSORIES
1. Press the MyQ ® Control Panel LEARN
button twice, the red learn LED will
turn on.
2. Press the LEARN button on the MyQ
device.*
LEARN
Button
Model 825LM - Remote Light Control
Light module can be synchronized with the
garage door opener light bulbs.
INTERNET GATEWAY
The LiftMaster ® Internet Gateway gives you control of your garage door
from your internet connected computer or mobile device. You must have
your internet gateway registered to your customer account at
www.myliftmaster.com in order to use it with the MyQ
to www.myliftmaster.com and follow the instructions to create an account
and register your device if you have not already.
To program your control panel to the LiftMaster
1. Go to www.myliftmaster.com from a computer or mobile device.
2. Click on "Manage Places>Add New Device>Garage Door Opener"
and follow the directions.
3. Once you click ADD you have 3 minutes to press the LEARN button
two times on the MyQ ®
on.
4. The red learn LED will turn off when programming is complete.
Once the control panel is learned, it will appear on your screen. You
can then name the device (e.g., My Control Panel, etc.).
® Control Panel LEARN
button twice, the red learn LED will turn
on.
that you wish to operate your garage
door.
(or two clicks will be heard) when the
code has been programmed.
®
Model 829LM - Garage Door and Gate Monitor
Indicates the status of your garage door from inside
the home and allows you to close an open garage door
from inside the house.
® Control Panel. Go
® Internet Gateway:
control panel. The red learn LED will turn
KEYLESS ENTRY
1. Press the MyQ ® Control Panel LEARN button twice, the red learn
LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of your choice
on the keyless entry keypad. Then press the ENTER button.
3. The garage door opener lights will flash (or two clicks will be heard)
when the code has been programmed.
Command
LED (yellow)
Learn
LED
(Red)
LEARN
Button
Model 828LM
LiftMaster
2
? ? ?
PIN
Model 823LM - Remote Light Switch
Light module can be synchronized with
the garage door opener light bulbs.
* MyQ ® accessories may be programmed to the
LiftMaster ® Internet Gateway (Model 828LM)
or the MyQ ®
control panel. For instructions on
programming to the internet gateway refer to
the manual.
® Internet Gateway
www.myliftmaster.com
?
LEARN
Button