Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Installation of the air conditioner
1.
Unpack the machine and accessories and check that the hose between the indoor and outdoor unit is properly connected. Also check whether the
condensation drain has a rubber cover. Finally, check whether the accessories are complete.
2.
Install the accessories as shown in the picture. Connect the outer bracket to the support block and the inner bracket by tightening the hand screws. This is
how you form the carrying handle.
2.1 Install the bracket as shown in the fi gure below. Install the indoor and outdoor units on the bracket to fi x the two parts. To secure the units to the bracket,
tighten the hand screws in the appropriate holes.
2.2 Place the shock resistant rubbers on the back of the outdoor unit.
Shockproof rubber dampers
2.3 Install the complete unit in the caravan window and tighten the bracket properly (see fi gure).
Indoor unit
lock
Shockproof rubber
dampers
bracket
Outdoor unit
hose
Publicité
Chapitres
Table des Matières
