Speedlink FULL METALL 5.1 SYSTEM Mode D'emploi page 13

Connecting to a DVD player:
You can connect the sound system to a DVD player or Dolby Digital Decoder.
GB
1. To do this, connect the supplied cinch cable
the 5.1 inputs (L Front R/Centre/Subwoofer/L Rear R) provided for this.
Connect the other end of the cables to your sound source (e.g. DVD player).
Note: The socket for each channel should be shown in the user manual of your
DVD player.
Configuration of the DVD player
To be able to output optimal 5.1 sound, you may have to configure your DVD player
and adjust the output of 5.1 sound. Read the user manual of your DVD player for
more details.
Connecting to a sound card:
To connect to a sound card, use the supplied jack to cinch connector
„Supplied with product).
Note: The sockets for the speakers should be shown in the user manual of your
sound card.
1. Connect the cinch plug to the 5.1 inputs on the back of the subwoofer and
the jack plug to your sound card.
Switching on:
Switch the system on with the Power On/Off switch on the front of the subwoofer.
(see „Supplied with product) to
14
.(see