Abus AZ4220 Instructions D'installation page 11

Activate the radio component (by triggering the tamper
contact if necessary).
The LED must be pointing to the learn sensor of the
extension module.
The extension module emits a double tone when the
radio component has been successfully trained. For
trained sensors, the signal strength (max. 9) is shown
on the left and the channel number on the right. The
channel is assigned automatically. A trained remote
control shows the number of the learned components
with the display "t 2" alternating with the signal strength.
Important: If radio components cannot be trained, the
extension module emits a single tone.
3. Repeat steps 2 and 3 to train further radio components.
Note that max. 8 radio remote controls can be trained.
4.3 Assigning sensors to zones
1. Put the extension module in learn mode.
2. Press "SELECT" until the desired zone number
appears.
If the display flashes, the zone is free. If the display is
constant, the zone is occupied.
3. Follow steps 2 and 3 from the section "Training radio
components".
4.4 Deleting sensors
1. Put the extension module in learn mode.
2. Press "SELECT" until the desired zone number
appears.
3. Press "DELETE" for about 4 seconds. A double tone
sounds and the display shows "--". The sensor is now
deletedBetriebshinweise
4.5 Deleting additional devices
These components cannot be deleted individually. To delete a
component, you have to delete all radio remote controls and
then retrain the ones you want to keep.
11