Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. WINTERIZE
1) Unplug the pump from the power source.
2) Close the shut off valves or block the flow of water al the pool inlet and return ports.
3) Disconnect the filtration system from the pool, drain the tank and hoses.
4) Place the handle on the central valve in position 7- "Winterize" to relieve the tension on
the spring and internal valve components.
5) Store the filter system in a location protected from frost and severely cold temperatures.
ln a garage or insulated storage shed is recommended.
7. TROUBLESHOOTING
MALFUNCTION
Pressure gauge has
reading over 1 bar
Pressure is too low
Air in the pump
Leaking
Pump does not run
Sand in Pool
Air in system
parts or in the case of a complaint, please contact our customer service:
Cause
Hair and lint strainer basket is dirty;
Pump gels too little water
Poor seal on the in-take side of the
pump.
Seal Defective C
Not plugged in C
G.F.C.1/ or main circuit breaker tripped
Pump motor defective R
If the sand is newly replaced, the under -
sized grains are still present
Sand in Central V alve (from back-wash) P
in-stalled
Filter bottom strainer is damaged
Solution
Clean the hair and lint strainer; check the
suction line and the water level
Tighten hose clamps and connecting
heck the seal, replace if needed
heck the socket and power cord
Switch on the breaker (if it is immediately
tripped again, there is a defect in pump
or controls)
eplace the entire pump
Backwash several limes until the
backwash water is clear (position 4)
urge into drainpipe for 30 seconds
(position 6)
Check the separation wall for proper
positioning
Loosen, but do not remove, the
allow any trapped air to escape. Tighten
the cover once ail of the air has escaped
EN
EN
Publicité
Table des Matières
