Interline 57100253 Instructions De Service page 17

5. STARTING
Once the filter system has been properly
assembled, the sand chamber filled
with sand and the hoses connected as
described above, you may begin with
filtration. However, we recommend that
you clean and prepare the new sand that
is in the sand chamber first. Cleaning
the sand prior to filtering your pool will
remove most of the dus! and tiny sand
particles that may exist in the sand. If you
move straight to filtering, these particles
will end up in your pool. To clean the sand,
please follow the instructions below. Do
not plug the system in until advised to do
so below.
1) Make certain the pump is not plugged
in to a power supply.
2) Start with the valve in the 5 Closed
position.
3) If you haven't done so already, fill your
pool with water. Ensure that the water
level is al least 2,5 - 5 cm above the top
of the hose intake (Skimmer) and return
ports in the pool.
4) Release the shut off valve al the intake
port (Skimmer) in the allow the water to
flow into the intake hose.
5) With the filter-pump system installed
in a location level lower than your pool's
water level - water will automatically flow
into the pump-filter system.
6) Allow the filter tank to fill with water.
7) Check for leaks and make any necessary
adjustments. Because of tolerances (in
consequence of the production process),
it is possible that it may be necessary to
use a Teflon tape additionally which has
to be wrapped around the connections,
before the connection tube is fixed, in
order to correct these tolerances.
8) Follow the backwash
described below.
Backwash Process
• Disconnect the Motor/Pump from the
Power Source.
• Attach backwash hose (not included) to
backwash port.
• Place the Multi-Port Valve in the «4 -
Backwash» position.
• Reconnect to power source.
• Run filter in BACKWASH mode until
discharge water is clear.
• Disconnect the Motor/Pump from the
Power Source.
• Place the Multi-Port Valve in the «2 -
RINSE» position. It is important that you
read and follow the instructions on proper
power supply sources.
• Reconnect to power source.
• Allow filter to run for 60 seconds to
remove any remaining residue from
pump and valve.
• Disconnect the Motor/Pump from the
Power Source.
• Place the Multi-Port Valve in the «1-
Filtration» position.
• Reconnect to power source.
Your filtration system is RUNNING and
ready for further operation.
Filtration time
Depending on the load and the size of
the installation, the pool water should
circulate at least 3 to 5 times through the
filter within 24 hours. The time required
depends on the performance of the
filtration group and the size of the pool.
We recommend a minimum operating
time of 12 hours per day.
process
EN