Magic Vac ® Bottle Caps; Vacuum Packing In Glass Jars; Vacuum Packing With; Vacuum Packing With Cap Attachment - Magic Vac Futura Instructions Sur Le Fonctionnement

FUTURA Ing. mew 23-12-2009
Warning: DO NOT LEAVE THE LID WITH LOCKS ENGAGED WHEN THE UNIT IS NOT IN USE.
used products such as dry and fragile foods; powder
foodstuffs; fresh, pureed or strained fruit and vegeta-
bles. Their transparency and design makes them
attractive to display on kitchen shelves while ensuring
that their contents are clearly visible.
- Fill the container leaving at least 3 cm of room
between the contents and upper rim and position
the cap on the container.
- Connect the container lid to the air inlet (6) of the
appliance (fig. O) by means of the connection hose
(15).
- Lock the lid (4) by pushing the LOCK buttons (7); the
machine will carry out a vacuum packing cycle and
turn off automatically on its completion.
- Remove the hose from the container lid.
- Press the central button (16) to open the containers
(fig. O).
8 Vacuum packing in glass jars sealed with metal
caps (Leifheit type)
Use the large-sized cap attachment to pack foods in
large-mouthed glass jars with a metal cap. A small-
sized cap attachment is also available for narrow-
mouthed jars sealed with metal caps.
- Fill the container leaving at least 3 cm of room
between the contents and upper rim.
- Connect the cap attachment (17) to the air inlet (6) of
the appliance by means of the connection hose (15).
Place the cap attachment directly on the jar with the
metal cap only (18) and press down, making sure it
fits correctly. (fig. P)
- Lock the lid (4) by pushing the LOCK buttons (7); the
machine will carry out a vacuum packing cycle and
turn off automatically on its completion. Make sure
that the cap attachment holds firmly by keeping it
pressed with your hand.
- Disconnect the hose from the cap attachment.
Remove the cap attachment from the jar.
8:34 Pagina 4
OPERATING INSTRUCTIONS
- Apply the ring (19) supplied with the jar and screw it
- To open a glass jar vacuum-sealed with a metal cap,
9 Vacuum packing with MAGIC VAC
The MAGIC VAC
ly filled bottles of wine or non-fizzy beverages. Using
the Bottle Cap will allow you to create a vacuum inside
the bottle so as to slow down oxidisation and preserve
the freshness and flavour of its contents for a longer
time.
- By means of the connection hose (15) connect the
- Lock the lid (4) by pushing the LOCK buttons (7); the
- Disconnect the hose from both the Bottle Cap and
- To open a bottle sealed with the MAGIC VAC
10 Vacuum packing with the cap attachment in
MAGIC VAC
sealed with MAGIC VAC
vious model of knob
To use the Cap Attachment in MAGIC VAC
containers or in containers sealed with MAGIC VAC
Universal Caps with the previous model of knob, read
the instructions supplied in our web page www.flaemn-
uova.it
17
down all the way (fig. P).
use the cap opener provided (the side with writing
should be turned up). Position the cap opener as
shown in figure Q and gently pry open the cap until
the vacuum is released. Remove the metal cap. This
accessory allows you to reuse the cap.
® Bottle Cap may be used to seal part-
air inlet (6) of the appliance to the MAGIC VAC
Bottle Cap (20) (fig. R). Press the Cap firmly into the
bottle.
machine will carry out a vacuum packing cycle and
turn off automatically on its completion.
the appliance immediately.
Cap, simply pull the cap out of the bottle. You will
hear the air rushing into the bottle.
® Executive containers or in containers
® Universal Caps with the pre-
® bottle caps
®
® Bottle
® Executive
®