Functions - Briteq PD-32SH/FR Mode D'emploi

ENGLISH

FUNCTIONS

A. GENERAL CIRCUIT BREAKER: protects ALL outputs, including the 32A output to the next unit. In case
of emergency all 3 phases AND the neutral are disconnected.
B. RESIDUAL CURRENT CIRCUIT BREAKER: this is a vital security device of the power distributor!
When someone accidentally touches one of the mains conductors, a current leak through the body of
this person could result in a lethal (deadly) shock. As soon as such current leakage in the installation is
detected, the power distributor outputs will be disconnected. The maximum allowable current leakage is
set to 30mA. Under normal working conditions the lever on the right should be in upward position.
Important: the functions of this device should be tested every 30days by pushing the test button on top:
as a result the outputs should be immediately disconnected from the mains.
C. INDIVIDUAL CIRCUIT BREAKERS: each of the 3 phases is secured by two C16 automatic circuit
breakers. Under normal working conditions the lever should be in upward position.
D. VOLT & AMPERE METERS: each of the 3 phases (L1, L2 & L3) have their individual meters.
E. 32A INPUT: 1,5m long mains input cable (3x 32A, 5wire), equipped with CEE (3P+N+E) inlet plug.
F. 32A OUTPUT: CEE (3P+N+E) outlet socket (3x 32A, 5wire), can be used to feed-through up to 32A
3phase current. Make sure that the total input current will not be exceeded!
G. 16A OUTPUTS: Each output has its individual circuit breaker (C) on the front panel
 Output 1: 230V/16A output socket connected to phase1 (L1) and protected by breaker 1 (C)
 Output 2: 230V/16A output socket connected to phase1 (L1) and protected by breaker 2 (C)
 Output 3: 230V/16A output socket connected to phase2 (L2) and protected by breaker 3 (C)
 Output 4: 230V/16A output socket connected to phase2 (L2) and protected by breaker 4 (C)
 Output 5: 230V/16A output socket connected to phase3 (L3) and protected by breaker 5 (C)
BRITEQ
®
3/27
USER MANUAL
PD-32SH