13. INSTALL THE BLOWER (P5
P8
)
AND
BLOWERS ONLY
The blower must be installed to the rough-in plate using four 3/8" screws. Remove the cover from the blower assembly. Remove the
impeller(s) by pulling it (them) out gently (see pictures below).
HD0021
HD0022
Install screws into the location as shown in the pictures below (P5 or P8 blower). Do not tighten screws down fully, leave a 1/8" gap. Hang
blower unit onto blower plate (screws through the large part of the keyhole). Slide the blower to its position (screws in the small part of the
keyhole). Tighten the screws.
P5 BLOWER
P8 BLOWER
HD0045
HD0044
Secure the blower by installing 2 more screws into the locations shown in the pictures below (P5 or P8 blower). Reinstall impeller(s) and
cover.
HD0080
HD0081
FRONT
FOR P8 DUAL BLOWER UNIT, ENSURE THE IMPELLERS
ARE CORRECTLY INSTALLED; THE HOOD WILL NOT
WORK PROPERLY IF REVERSED. Both impellers are
different in the dual blower, one rotates clockwise and the other
1
2
counterclockwise. Each wheel and motor have an arrow and
a number on them, you have to match them correctly (see
drawing at right).
HD0023
10