Kobalt 0832476 Mode D'emploi page 9

ASSEMBLY INSTRUCTIONS
ASSEMBLING THE BLOWER TUBE
1. Before tube installation, place the hose clamp (J)
around the flex tube. Clamp may need to be slightly
loosened for tube installation.
2. Insert the shorter end of the upper blower tube (B)
assembly into the flex tube (G) at a slight angle.
3. Use one end of the tube as a pivot point, and press
the other side into the flex tube. This may require
some force.
4. Stop pressing the upper blower tube when it
connects to the flex tube. Fully tighten the screws
on the hose clamp(J) once assembled. Use a
screw driver (not provided) to loosen and tighten
the hose clamp. Turn clockwise to tighten, and
counter clockwise to loosen.
5. Place the cord (L) in the cord retainer (K).
6. Connect the blower tube (C) to the operating tube
(B). Twist clockwise until the tubes lock into
postion.
Note: Never operate the blower with the nozzle not
fully assembled and locked.
3
B
4
C
9
G
J
K
L
B