Remote Control - Sonnenkonig SUMATRA Mode D'emploi

• Press the control switch once. The main unit is turned on and operates with
GB
a low setting. The LED flashes green
• Press the power switch again. The main unit operates with a higher setting.
The LED flashes red
• Press the control switch again to enter programming mode. The LED flashes
orange
• To turn off the unit, press the power switch a fourth time
The unit switches off automatically after 20 minutes. It is recommended not to
use the device for more than 30 minutes at a time. Please wait at least 10 minu-
tes until the main unit has cooled down before switching it back on.

REMOTE CONTROL

After carefully climbing into the bath, you can turn on the unit and adjust the
bubble intensity with the remote control (#4). Please note that the remote control
does not have LED lighting. The remote control also has a suction cup on the
back. Simply moisten the suction cup and press it firmly against the bathtub wall
or against the side of the bathtub. Do not immerse the remote control in water.
• Always point the remote control at the infrared reception area on
the handle to operate the unit.
• By pressing the button on the remote control repeatedly, the unit
operates in the same sequence as described in the Control
section:
- On / Low level
- High level
- Program Mode
- Switched off
The remote control uses a 3V CR2032 battery (already included).
The battery compartment is located on the back of the remote
control. To replace the battery, open the lid with a coin. Make sure
the battery is inserted correctly and close the cover with a coin.
Disposal of batteries
Batteries should not be disposed of with household waste. As a consumer, you
are required by law to take all used batteries to public collection points in your
area or to places where batteries of this type are sold.
52