Preparation - Sonnenkonig SUMATRA Mode D'emploi

GB

3 Preparation

• Remove the head unit (#1.1) and all accessories from the packaging. Please check
whether the product is complete and undamaged
• Ensure a pleasant room temperature in the bathroom
• Before using the product for the first time, we recommend that you thoroughly
clean your bathtub so that the mat adheres better to the bathtub floor
• Make sure the head unit is not connected. Place the main unit on the floor or on
a level, stable surface. Make sure that the air inlet on the underside is not covered
• Place the mat (#3) in the bathtub with the air connection on the mat at the foot
end. Press down on each suction cup. Tip: The suction cups adhere better if you
moisten the bottom of the bathtub with a little water
• The suction cups under the mat work perfectly on smooth and shiny tub surfaces.
If your bathtub has a rough or textured surface, please ensure that it does not slip
when entering the bathtub and that there is a possible danger
• Connect the end of the hose (#2.3) to the connector on the mat. Connect the end
of the hose (#2.2) to the main unit and make sure that it is locked counter-
clockwise
• Start filling the bathtub with water. Ensure a pleasant water temperature.
• Do not use bath foam or bath salt
• Plug the power cord into the wall outlet
ATTENTION
For safety reasons, the main unit must be placed at least 60 cm from your ba-
thtub. Do not place the main unit so that it can fall easily or be pulled into the
bathtub or onto the wet floor. Always place the unit on dry ground.
Mat
50
Connector
Suction cups