Specifications; Operation; Battery Information - Cuda surgical LED ROVER Mode D'emploi

4. SPECIFICATIONS

Item
Lamp Type
Color temperature
Lamp life
Battery
Current converter output
Discharge time
Model
Dimensions
Weight
Electrical Protection
Medical Classification

5. OPERATION

The LED Rover is operated by a pushbutton switch inside a protective silicone rubber
boot at the back end of the handle. It features a momentary ON function with partial
depression of the switch, and clicks to stay ON with full depression. Depress the switch
fully again to turn it off.

6. BATTERY INFORMATION

6.1 DISPOSABLE BATTERY MODEL
BATTERY REPLACEMENT
Unscrew the headpiece that houses the LED. (Do not remove the switch; the batteries
cannot fit through the switch end.)
Observe correct polarity. The positive (+) end of both batteries must point toward the
headpiece. The positive end of the battery has a protruding nipple, the negative (-) end
is flat.
NOTE: Because discharge characteristics may vary between designations or
between used and unused batteries, always replace batteries in pairs with pairs
of identical new batteries.
Replace disposable 3 volt Lithium CR123 primary batteries only with similar size and
voltage batteries.
Storage: Store in a dry area at 40º F – 85º F.
®
LIT102 CUDA
(English)
Specification
LED
6500° K (nominal)
50,000 hrs. (nominal)
Lithium CR123, 3Volts (2X) or Lithium Ion RCR123A 3V
(2X)
611 milliamps (nominal)
110 minutes (typical, actual endurance may vary)
LED Rover
5.1 inches long X 1.25 inches diameter at LED housing
3.7 oz.
Class I, Type BF
FDA Class II
Europe Class I
Surgical
Remove the old batteries and insert the new ones.
Rev. P
Date of Revision:11/11/15
Page 5 of 40