HEADRUSH LOOPERBOARD Guide D'utilisation Rapide page 17

Audio Routing
You can use the Audio Routing page to control where your input, looper track and output audio signals
are sent. These settings are global settings (not per loop) so that you can quickly configure HeadRush
Looperboard to work best for your gear and performance settings.
To show the Audio Routing page, tap the Audio Routing icon on the Navigation Menu page.
To show the page for the inputs, tracks, or outputs, tap Input Setup, Track Setup or Output
Setup, respectively.
Input Setup
To adjust the level of an input signal, turn its
Input Gain knob (1–4) on the top panel.
To adjust the panning of an input signal, tap its
Pan slider and drag left or right. You can enlarge
this slider to make more detailed adjustments by
double-tapping.
To select an output to directly monitor the input
signal, tap the desired Output 1–4 button under
Dry Sends or the Headphones Icon button under
Monitor. Audio signal from the input will be sent
directly to the selected output(s). Use the Main and
Phones knobs to adjust the output volume level of
the outputs and phones, respectively.
To stereo link your inputs if you are using a stereo audio source (e.g., drum machine, keyboard,
etc.), tap the On button for Inputs 1+2 and/or Inputs 3+4 under Stereo Link on the right side of the
touchscreen. Tap the Off button to disable stereo link.
Monitor Setup
You can use the Monitor Setup page for listening
to your inputs while recording, overdubbing, and
playing back loops. You can control the level of
each input, as well as which output that you would
like to monitor to them on.
To adjust the monitor level of an input, tap and
drag the white line at the top of its meter.
To select an output for monitoring, tap the
desired Output 1–4 buttons under Sends or the
Headphone Icon button Monitor.
17