Furrion FMCM17-BL Manuel D'instructions page 22

Care and Maintenance
E-14 - Preheat alarm:
During preheat process, if the oven cannot
reach the preheat temperature within 30
minutes, the oven beeps and show"E-14". For
troubleshooting, press Stop/Cancel pad to
return normal condition.
E-15 - Low Temperature
Protection:
While entering into low temperature
protection status, the oven beeps and the
display shows "E-15". For troubleshooting,
press Stop/Cancel pad to return normal
condition.
E-21 - Humidity sensor open
circuit:
When the humidity sensor is open circuited,
the oven enters into protection mode
and beeps, the display shows "E-21". For
troubleshooting, press Stop/Cancel pad to
return normal condition.
E-22 - Humidity sensor short
circuit:
When the humidity sensor is short circuited,
the oven enters into protection mode
and beeps, the display shows "E-22". For
troubleshooting,, press Stop/Cancel pad to
return normal condition.
E-23- Maximum time alarm:
When the humidity sensor cooking reached
the longest time, the oven beeps and shows
"E-23". For troubleshooting, press
Stop/Cancel pad to return normal condition.
E-24:
During sensor menu cooking process, if you
open the oven door for 5 seconds, the oven
beeps and the display shows "E-24". For
troubleshooting, press Stop/Cancel pad to
return normal condition.
21
E-d1- Pad adhesion alarm:
In any state, if any pad on the control panel
is closed for 10 seconds, the system will
beep and the display will show "E-d1", after
troubleshooting, press Stop/Cancel pad to
return normal condition.
Exterior
The outside surface is pre-coated steel and
plastic. Clean the outside with mild soap
and water; rinse and dry with a soft cloth. Do
not use any type of household or abrasive
cleaner.
Door
Wipe the window on both sides with a damp
cloth to remove any spills or spatters. Metal
parts will be easier to maintain if wiped
frequently with a damp cloth. Avoid the use of
spray and other harsh cleaners as they may
stain, streak or dull the door surface.
Touch Control Panel
Care should be taken in cleaning the control
panel. If the control panel becomes soiled,
open the oven door before cleaning. Wipe the
panel with a cloth dampened slightly with
water only. Dry with a soft cloth. Do not scrub
or use any sort of chemical cleaners. Close
door and press STOP/CANCEL.
Interior
How to clean the interior surfaces, wipe
with a soft cloth and warm water. DO NOT
USE ABRASIVE OR HARSH CLEANERS
OR SCOURING PADS. For heavier soil, use
baking soda or a mild soap; rinse thoroughly
with hot water.
Waveguide Cover
The waveguide cover is located on the
side of microwave oven. It is made from
mica so it requires special care. Keep the
waveguide cover clean to assure good oven