Controls - Panasonic VL-WD812EX Information De Produit

Controls

B A
C
D
E F
Indicator lamp (See the following explanation.)
LED lights
R Automatically lights when it is dark and the camera is monitoring or when sensors are operating. (The LED
lights are designed to be used as warning lights for intruders and are not meant to be used for illumination.)
Lens cover
R Contains a lens and a brightness sensor. (See the following explanation.)
Sensor range cap (standard type)
R 4 types of lens caps (accessories) can be fitted as required. (® Installation Guide)
Heat sensor
R Detects changes in temperature. (® page 5)
Microphone
Speaker
Safety wire
Heat sensor lever
R Used to change the angle of the heat sensor. (® Installation Guide)
Register button (behind the register button cover)
R The register button is located behind the register button cover.
Used when registering the camera to the main monitor. (® Installation Guide)
Brightness sensor
Determines whether to light the LED lights by detecting the brightness of the surrounding area.
Indicator lamp
After the camera has been registered to the main monitor, you can check the camera's status and the wireless signal
status from the main monitor by checking the status of the indicator lamp.
Indicator display
Flashing green
(fast)
Transmission
status
Flashing green
(slow)
Rear view
G
A sensor has been triggered and the camera is calling the main monitor.
The camera is transmitting data to the main monitor.
H
I
Camera's status
J
7