Connection; Connecting The Audiorama 9000; Important - Grundig Audiorama 9000 Mode D'emploi

CONNECTION

Connecting the Audiorama 9000
The nominal load of your Audiorama 9000 may
not exceed 120 watts.
The rated impedance of your Audiorama 9000 is
4 Ohm. Please note that the amplifier used must
be able to accomodate a minimum impedance
(acc. to IEC) of 4 Ohm.
The related amplifier should provide sufficient
output power.
An amplifier that provides less output power will
produce dangerous distortions for the individual
speakers even at moderate volumes.
If the sound controls (bass and treble) are
turned up at louder volumes, the operating limit
will already have been reached. The amplifier
generates heavy distortion even when well under
the maximum volume.
1 Before connecting the loudspeakers, switch off
the amplifier.
2 The loudspeakers must be connected to the am-
plifier observing the correct polarity.
The connection terminals of the amplifier are
marked (for example, red = positive pole, black =
negative pole). The wires of the connection cable
are likewise marked.
Connect the marked – or red – wires of the con-
nection cable with the red connections (positive
pole) of the amplifier and the unmarked – or
black – wires of the connection cable with the
black connections (negative pole) of the ampli-
fier.
Incorrect connection can lead to sound distor-
tions.
13 ENGLISH
----------------------------------------------------------------------------------------------------------------------

Important:

Make sure that the two connection cables
■
do not contact each other. A short-circuit
could otherwise occur, resulting in damage
to the amplifier.