Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MOUNTING
7 Using the terminal strip (2.5 mm
loudspeaker cable and its extension to the am-
plifier.
Notes:
Connect the loudspeakers observing the cor-
■
rect polarity.
The cross-section of the loudspeaker cable
■
extension used must have a certain ratio to
the cable length.
We therefore recommend a cross-section
■
of at least 1.5 mm
10 meters and a cross-section of at least
2.5 mm
2
for lengths over 10 meters.
If you use cross-sections of > 2.5 mm
■
ers can be obtained from your dealer.
8 If necessary, cut a section out of the covering
for the loudspeaker cable.
9 Snap the covering onto the mounting plate.
Note:
Fasten the loudspeaker cable to the wall or
■
floor. Loose loudspeaker cables pose an ac-
cident hazard.
-----------------------------------------------------------------------------------------------------------------------------
2
), bind the
2
for cable lengths under
2
, reduc-
Setting up the Audiorama 9000
with a stand support
As an alternative to mounting the Audiorama
9000 on the ceiling, you can also set it on a stand
support.
The stand support is available as an accessory
from your dealer.
Mounting the stand support may only be carried
out by an authorised dealer.
ENGLISH
12
Publicité
Chapitres
Table des Matières
