Mounting; Mounting The Audiorama 9000 On The Ceiling - Grundig Audiorama 9000 Mode D'emploi

MOUNTING

Mounting the Audiorama 9000
on the ceiling
Caution:
The ceiling surface must be strong enough to
■
bear the weight.
Use fastening equipment suitable for the
■
weight of the unit (Audiorama 9000 weight
including DIN safety = approx. 28 kg).
For ceiling constructions such as wood-
■
panelled or dropped ceilings, use suitable
anchors and screws. Consult your specialist
dealer.
Warning:
To avoid injury, this device must be properly
■
mounted on the ceiling according to the as-
sembly instructions.
Note:
If the Audiorama 9000 is to be used in a
■
professional environment (e.g. in a café), it
must be installed by a qualified electrician in
accordance with the valid installation speci-
fications of VDE 0100.
1 Select the mounting site and mark the holes on
the ceiling with the aid of the mounting plate for
the holder.
2 Drill the holes on the ceiling and insert the an-
chors.
3 Shorten the loudspeaker cable to the required
length, separate the wires approx. 50 mm and
remove about 10 mm of their insulation.
11 ENGLISH
-----------------------------------------------------------------------------------------------------------------------------
Note:
Before severing, wrap tape around the cable
■
sheath.
4 Slide the cover onto the loudspeaker and guide
the loudspeaker cable with steel cable through
the opening of the mounting plate.
5 Put the steel cable through the opening of the
locking screw and tighten it with a spanner (min.
2.5 Nm).
6 Screw the mounting plate over the spacers with
three suitable screws.