Safety Devices; Instructions For Installation; Reminders For The Installer - Gastro M 60/30 PVE Serie Installation-Emploi-Entretien

PACKING
The packing is made using environmentally
friendly materials. The plastic recyclable
components are:
- the transparent cover, the bags containing the
instructions manual and nozzles (made of
Polyethylene - PE).
- the straps (in Polypropylene - PP).
APPLIANCE
The appliance is manufactured 90% from
recyclable metals (stainless steel, aluminium
sheet, copper.. .. ).
The appliance must be scrapped in compliance
with current regulations governing such disposal.
Make the appliance unusable before scrapping.
It must be disposed of properly.
THE SYMBOL SHOWING A CROSSED-
OUT WASTE CONTAINER ON THE
UNIT OR PACKAGE INDICATES THAT,
AT THE END OF ITS LIFE CYCLE, THE
PRODUCT MUST BE COLLECTED
SEPARATE FROM OTHER WASTE.
THE DIFFERENTIATED COLLECTION OF THIS
EQUIPMENT IS ORGANISED AND MANAGED BY
THE PRODUCER.
THE USER WHO INTENDS TO GET RID OF THIS
EQUIPMENT SHALL CONTACT THE PRODUCER
AND FOLLOW THE SYSTEM THAT THE LATTER HAS
USED IN ORDER TO COLLECT THE EQUIPMENT
SEPARATELY AT THE END OF ITS LIFE.
PROPER SEPARATE COLLECTION HELPS PREVENT
POSSIBLE NEGATIVE IMPACTS ON THE
ENVIRONMENT AND HEALTH, AND FAVOURS THE
REUSE AND/OR RECYCLING OF THE UNIT'S
MATERIALS.
ABUSIVE DISPOSAL OF THE PRODUCT BY THE
HOLDER WILL RESULT IN THE APPLICATION OF
PENALTIES AS PER CURRENT STANDARDS.

2. SAFETY DEVICES

SOLID TOP (900 SERIES)/ELECTRIC OVEN
SAFETY THERMOSTAT
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
The appliance is equipped with a manual reset
safety thermostat that interrupts heating when
the operating temperature exceeds the maximum
permitted value.
To restore appliance operation, remove the
control panel and press the thermostat reset
button. This procedure must only be carried out
by a qualified, authorized technician.
SOLID TOP (700 SERIES)
The red indicator light (located on the control
panel next to the yellow indicator light) switches
on in the event of a fan fault: in this case
immediately switch off the appliance and call the
technical service centre.
This indicator light comes on when the thermal
fuse trips. The thermal fuse must be replaced
together with the fan.
INSTRUCTIONS FOR
II.
INSTALLATION

3. REMINDERS FOR THE INSTALLER

READ THIS MANUAL CAREFULLY. IT
PROVIDES IMPORTANT
INFORMATION FOR SAFE
INSTALLATION, USE AND
MAINTENANCE OF THE APPLIANCE.
FAILURE TO COMPLY WITH WHAT IS
PRESENTED BELOW MAY
COMPROMISE THE SAFETY OF THE
EQUIPMENT.
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR INJURY
RESULTING FROM FAILURE TO
OBSERVING THE FOLLOWING RULES.
Identify the specific appliance model. The model
number is detailed on the packing and on the
appliance dataplate.
The appliance must be installed in a well-
ventilated room.
Installation and conversion to a different type of
gas must be carried out by qualified technicians
authorized by the manufacturer, in compliance
with current safety standards and the instructions
in this manual.
17