Lock/Unlock The Doors; Cleaning, Care & Maintenance; Auto Defrost; Troubleshooting - Polar CE322 Mode D'emploi

Lock/Unlock the Doors

A lock is fitted to the doors of this POLAR appliance.
Use the keys provided to lock/unlock the door.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must carry out repairs if required.
• If left unused for any length of time, store the appliance with the door ajar.

Auto Defrost

Periodically the appliance will run an automatic defrost cycle to prevent any ice build-up.

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault
The appliance is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The appliance turns Too much ice on the evaporator
on, but the
Condenser blocked with dust
temperature is too
high/low
Doors are not shut properly
Appliance is located near a heat
source or air flow to the condenser
is being interrupted
Ambient temperature is too high
Appliance is overloaded
The appliance is Loose nut/screw
unusually loud
The appliance has not been
installed in a level or stable
position
3
Probable Cause
Check the unit is plugged in correctly and switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified Technician
Defrost the appliance
Call POLAR agent or qualified Technician
Check doors are shut and seals are not damaged
Move the refrigerator to a more suitable location
Increase ventilation or move appliance to a cooler
position
Reduce the amount stored in the appliance
Check and tighten all nuts and screws
Check installation position and change if necessary
Action