Connection Via Line-Out; Connection Via Fm Transmitter; Search And Select Dab+ Channels - ONYNO 8.0 Mode D'emploi

3.4 Connection via Line-Out

1. Connect the 3.5mm line-out socket of the Model 8.0 through the
supplied audio cable with the line-in socket of your car rado. A
headphone icon will be displayed at the top of the blue bar.

3.5 Connection via FM Transmitter

1. Press the "TX/Scan" button to enter the FM transmitting frequency
selection mode.
2. Then use Tuning Knob to select your desired vacant frequency (based
on your past experience with the known vacant frequency) which you
would like to receive by your car radio.
3. Once it is selected, press "Mode" button to confirm and exit or the
screen will go back to DAB+ mode automatically after 3 seconds and the
selected frequency will be shown at the top of the blue bar, e.g.
TX87.6MHz.
Remarks: "Vacant frequency" means there is no radio broadcasting
content or noise when the frequency is selected.

4 Search and select DAB+ channels

1. Press the "Mode" button until "DAB+ Radio" mode is found
2. Use the Tuning Knob to select the desired DAB+ channel
3. Or press "PRESET" button to enter the station list, usethe Tuning Knob
to scroll up or down to select the desired DAB+ channel and press the
"Mode" button to select.
4. You may also press and hold the "TX/Scan" button for 3 seconds to re-
activate the "Auto Scan" process if you need to update the DAB+ radio
channels.
Remark: For normal use, you don't have to perform the "Auto Scan"
every time you use the car DAB+ radio unless there are newly added
DAB+ channels, then you may need to perform the "Auto Scan" again.
The scanning operation is similar to your home TV set.
24