Radio Operation; Dab+ Mode - auna multimedia Sheffield Mode D'emploi

DAB+ differs from analogue radio; the separate signals from a number of stations are grouped together and
transmitted as a single frequency. These groups are referred to as multiplexes and ensembles. Each time a
group has been found the name of the group will be shown on the lower half of the display.
When the device is powered up for the first time, an automatic scan will be performed. You can also tune
manually:
• Use the arrow keys to move through the DAB+ channels and the associated frequencies. When the
desired ensemble / frequency appears in the display, press the SELECT button to tune in.
Saving Presets:
• Press and hold PRESET until the display shows the flashing PRESET number (lower right display corner).
• Use FORWARD / BACKWARD to select the preset storage location of choice and then press SELECT to
confirm. The station now broadcasting has now been stored in the selected location.
• To listen to a preset station, press PRESET and then use FORWARD / BACKWARD to select the desired
preset location. When the storage location of choice is displayed, press SELECT to listen to the stored
station. If the preset has not been allocated „Preset empty" will be shown in the display.
• Turn the radio on and press MODE button to select the FM mode. The display will show „switching to
FM" and the radio will tune to 87.50 MHz.
• To activate auto search, briefly press the SCAN button and the radio will start scanning up the frequen-
cy and stop automatically once the next station up has been found. To scan downwards, press and
hold the SCAN button for at least 1 second.
• Use FORWARD / BACKWARD to increment the frequency by 0.05MHz and tune manually.
• If an FM RDS (Radio Data Signal) is present, the display will automatically show the station name and
radio text (where available).
• To save stations as preset stations, follow the routine explained in the DAB+ section above („Saving Pre-
sets)
14

Radio Operation

DAB+ Mode

FM Mode