Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Plug in the AC cord to the AC outlet. The unit will go to standby mode and the Standby LED indicator
will light up.
•
Turn on the unit with
mal. Now your system is ready to play the music.
•
Press
to switch to standby.
•
Press and hold MEM/CLK-ADJ until the display shows„24HR". Use
format. Confirm pressing MEM/CLK-ADJ.
•
Adjust the hours using
•
Repeat this procedure for the minutes adjustment.
Please note:
•
The clock setting mode will automatically quit if no button is being pressed in a period of about
5 seconds after pressing the " Mem/Clk-Adj " button.
•
The pre-set time will be re-set completely if dis-connecting the main power supply except backup
battery installed. You are recommended to switch the system into standby mode.
Switch the device on and press FUNCTION repeatedly to select the radio mode.
•
Use
/
for manually tuning in for stations.
•
For an automatic scan, hold one of the
station that will be tuned in.
•
Save stations as presets by pressing and holding MEM/CLK-ADJ until „MEM" appears on the display.
/
Use
, to select the desired preset (20 available) - confirm with MEM/CLK-ADJ.
Please note:
•
The memory function will be cancelled completely if dis-connecting the main power supply ex-
cept backup battery installed. You are recommended to switch the system into standby mode for
convenient usage.
•
After 5 secs without any change the device will resume to normal tuner mode automatically.
•
You can overwrite a present station by storing another frequency in its place.
•
RDS mode: Press RDS mode button to active the RDS function and the program service station name
(PS) is being displayed.
•
RDS search: Press RDS search button to select the program type you want to listen, then press the tu-
ning +/- button to start RDS searching and the unit will automatically search a suitable station, which is
currently broadcasting with program type identification (PTY) signal. If there was no any broadcasting
station match your selection, display will show NO MATCH and then stay back in previous frequency.
20
, if the LCD display is on with backlighting, it means the power supply is nor-
Setting the clock
/
, then confirm with MEM/CLK-ADJ.
Radio Operation
/
/
buttons. The scan stops at the next found receivable
to toggle 12h or 24h clock
Publicité
Table des Matières
