Safety Instructions - CTC VT 50 Instructions D'installation Et D'entretien

English

Safety instructions

•
•
•
•
•
•
•
•
•
•
•
•
Recycling
•
•
•
This device can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the device in a safe
way and understand the hazards involved.
Children should not play with the device.
Cleaning and user maintenance shall not be performed by children without
supervision.
Installation should be carried out in accordance with the valid regulations and
according to the instructions of the manufacturer and by qualified staff.
In a closed-circuit, pressurised system, it is obligatory to install a safety valve with a
maximum nominal pressure indicated in the technical data, preventing the pressure in
the tank from exceeding the nominal pressure by more than 0.1 MPa (1 bar).
The outlet of the safety valve should be installed facing downwards and in a non-
freezing area.
To ensure proper functioning of the safety valve, the user should perform regular
controls to remove limescale and make sure the safety valve is not blocked.
Do not install a stop valve between the buffer tank and the safety valve, because it will
impair the pressure protection of the buffer tank!
A buffer tank that is connected to the heating system increases the volume, which
has a significant impact on the size of the expansion tank, which is obligatory and the
volume of which must be properly calculated by a professional.
If the system has to be switched off, please drain any water from the buffer tank to
prevent freezing.
If you are planning to build in an electric heating package, the safety of operation is
guaranteed only if an original heating package is installed.
Please do not try to fix any defects of the buffer tank on your own. Call the nearest
authorised service provider.
Our products incorporate components that are both environmentally safe and
harmless to health, so they can be disassembled as easily as possible and recycled
once they reach their final life stage.
Recycling of materials reduces the quantity of waste and the need for production of
raw materials (e.g. metals) which requires a substantial amount of energy and causes
release of harmful substances. Recycling procedures reduce the consumption of
natural resources, as the waste parts made of plastic and metal can be returned to
various production processes.
For more information on waste disposal, please visit your waste collection centre or
the store where the product was purchased.
5
CTC VT 50 - 300