Three-Phase Connection - Amitek AP10 Manuel D'installation, Utilisation Et Entretien

The following electrical safety devices have been applied:
1. start up with start/stop button that must be pressed again to restart the machine after an outage of
power main;
2. microswitch on the bowl lid as preventing machine startup when the lid is open;
3. microswitch as preventing machine from starting without first having lifted the bowl.
INSTALLATION AND FUNCTIONING TESTS
Open the carton and make sure that all components are intact.
Lift the machine (Fig. 2) according to the instructions and place it in its selected setting for installation.
Place the machine on a suitably plane, smooth and dry surface sufficiently strong to support the machine
weight.
Install near an outlet complying to EU and derived from an electrical system made to current regulations.
Before completing the connections, check that the mains correspond to the data shown on the plate.

THREE-PHASE CONNECTION

Remove any tool mounted. Close the protection grid and lift the bowl. Place the gear lever in position 1 (Fig.
5). Start the machine for just a few seconds and check that the planetary turns in the clockwise direction (see
arrow on the machine or Fig. 4). In the case where the rotation is not correct, disconnect power and
exchange two of the three phase wires in the plug.
AVAILABLE CONTROLS (Fig. 3) AND MACHINE USE
1. STOP BUTTON: press the button to stop the operation of the machine;
2. START BUTTON: press the button to start the machine; the startup is enabled only when the lid is
closed, bowl top and set timer;
3. TIMER: it allows the working time to be set; timed operation position (0 to 15 minutes): turn the
knob clockwise on the graduated scale;
4. TOOL SPEED ADJUSTMENT LEVER: allows to adjust the speed of rotation of the tool as a function
of the processing to be performed (three gear positions); ATTENTION: please stop the machine
before change the speed;
5. LEVER BOWL LIFT: allows you to raise or lower the bowl.
PLACEMENT BOWL
1. Lower the tank by turning the lever side.
2. Insert the pin back and two side brackets of the tank in their seats.
3. Act on the side levers to lock the bowl.
4. Raise the bowl by turning in the opposite direction the lever side.
PLACEMENT TOOL
1. Lower the bowl completely by rotating the lever side.
2. Open the lid and insert the tool on the shaft. Then lock it by rotating it clockwise.
3. Close the lid and lift the bowl by rotating the lever side.
MACHINE USE
1. Select a speed with the transmission in function of the type of processing: for hard dough select a
low speed (1), for soft dough select a high speed (2 or 3). Open the lid of the bowl to enter the
ingredients and close the lid.
2. Select a processing time using the timer.
3. Start the machine by pressing the START button.
4. At the end of the process to stop the machine by pressing the STOP button; if you have set the timer
function will turn off the machine when the timer back to zero.
5. Turn the lever side to lower the tank, turn the side levers to release it to discharge the product
worked.
6. After processing, rinse the tank and the tool with warm water and detergent.
7. Clean the lid with a damp sponge.
WARNING
Stop the machine before changing speed.
6