Specifications; Standard Equipment; Tool Inspection - RIDGID RP 210 Manuel

Masquer les pouces Voir aussi pour RP 210:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Specifications

RP 210-B Battery Press Tool:
Motor
Voltage ...................18V DC
Amperage ...............18 Amp
Power .....................324 Watts
Weight ........................5.6 lbs. (2.5 Kg) (Tool Only - No
Battery)
Ram Force .................5,400 lbs. (24kN)
Operating Temperature
Range ...........................15°F to 140°F (-10°C to 60°C)
0°F to 140°F (-20°C to 60°C) with
Battery Maintained Above 15°F
(-10°C) or By Using Higher
Capa city Batteries. See Cold
Weather Operation.
Duty Cycle...................3 Crimp
The Press Tool serial number plate is located at the bot-
tom of the handle as shown in Figure 2. The first 4 digits
indicate the month and year of the manufacture. (10 =
year, 05 = month).
Figure 2 – Press Tool Serial Label
NOTE! RIDGID jaws and attachments are offered in two
"series"
• Standard Series
• Compact Series
These series are not interchangeable. Only stan-
dard series jaws will work with standard series
tools (RP 330, RP 340, 320-E, CT-400). Similarly,
only compact series jaws will work with the com-
pact series tools (Compact 100-B, RP 200, RP
210). Please refer to the standard tool's operator's
manuals for further information on standard tools
and jaws.
/min.
RP 210 Press Tool
Selection of appropriate materials and join-
NOTICE
ing methods is the responsibility of the system designer
and/or installer. Before any installation is attempted, care-
ful evaluation of the specific service environment, includ-
ing chemical environment and service temperature, should
be completed. Consult Press Fitting System manufac-
turer for selection information.

Tool Inspection

WARNING
Daily before use, inspect your press tool and cor rect
any problems to reduce the risk of serious injury
from electric shock, crushing injures, attachment
failure and other causes, and prevent tool damage.
1. Make sure that the press tool battery is removed.
Inspect the battery for damage. If any damage or
modifications are found, do not use until the battery
has been properly repaired or re placed.
2. Clean any oil, grease or dirt from the equipment,
especially the handles and controls. This helps to
pre vent the machine or controls from slipping from
your grip.
3. Inspect the press tool for any of the following:
• Proper assembly, maintenance and completeness.
• Any broken, worn, missing, misaligned or binding
parts.
• Make sure that the attachment mounting pin moves
smoothly between the fully open and full closed
position and locks into each. Confirm that the
switch moves freely and does not bind or stick.
• Presence and readability of warning labels. See
Figure 3.
• Any other condition which may prevent safe and nor-
mal operation.
If any problems are found, do not use the press tool
until the problems have been repaired.
4. Inspect and maintain the tool attachments, battery
charger and any other equipment or material in use as
directed in their instructions.
5

Publicité

Table des Matières
loading

Table des Matières