Onkyo UP-DT1 Manuel D'instructions page 14

Using a UP-A1 Dock
When the UP-DT1's Mode Selector is set to TUNER,
the iPod in the connected UP-A1 dock will not be
charged. If you change the Mode Selector from
TUNER to THROUGH while your Universal Port-com-
patible Onkyo product is in Standby mode, you must
remove and reinsert the iPod in the UP-A1 to start
charging.
* iPod is a trademark of Apple Inc., registered in the
U.S. and other countries.
14
En-
Troubleshooting
If you have any trouble using the UP-DT1, look for a
solution in this section.
The UP-DT1 is not recognized by your Universal
Port-compatible Onkyo product
• Make sure the UP-DT1 is properly connected to
the UNIVERSAL PORT on your Universal Port-com-
patible Onkyo product.
• Turn off all devices before connecting to a UNIVER-
SAL PORT.
No sound
• Make sure your amplifier's volume control is not
set to minimum.
• Check all connections and correct as necessary
(see page 6).
The UP-DT1 is connected to a Universal Port-com-
patible Onkyo product but doesn't work
• Turn off all devices, and then set the UP-DT1's
Mode selector to TUNER.