Operating The Device Safely - Dometic WAECO CoolPower MPS50 Instructions De Montage Et De Service

CoolPower MPS50
2.3 Safety when connecting the device electronically
DANGER! Danger of electrocution
D
 For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the device installed by a specialist
(marine) electrician.
 If you are working on electrical systems, ensure that there is
somebody close at hand who can help you in emergencies.
WARNING!
!
 Always use sockets which are grounded and secured by
residual current circuit breakers.
 Make sure that the lead has a sufficient cross-section.
 Lay the cables so that they cannot be damaged by the doors or
the bonnet.
Crushed cables can lead to serious injury.
CAUTION!
!
 Lay the cables so that they cannot be tripped over or damaged.
NOTICE!
A
 Use ductwork or cable ducts if it is necessary to lay cables
through metal panels or other panels with sharp edges.
 Do not lay the 230 V mains cable and the 12 V DC cable in the
same duct.
 Do not lay the cable so that it is loose or heavily kinked.
 Fasten the cables securely.
 Do not pull on the cables.
2.4

Operating the device safely

DANGER! Danger of electrocution
D
 Do not touch exposed cables with your bare hands. This applies
especially when operating the device from the AC mains.
 To be able to disconnect the device quickly from the mains, the
socket must be close to the device and be easily accessible.
EN
General safety instructions
19