Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2610052572_GKF125CE 9/18/18 12:11 PM Page 11
▶ Installing the Motor into
PR101 Fixed Base
1.
Open the clamping knob to the
unlocked position
2.
Align the slot on the motor with the
pin on the base (Fig. 7)
of your hands away from the top rim
of the base and away from metal
section of the motor when pushing
motor into base.
3.
Push the motor into the base to the
approximate desired position has
been reached. Do not press on the
flap in the base while installing the
motor.
4.
Turn the clamping knob to the
bottom, locked position
9). Always make sure the motor
sits tightly in the base.
▶ Check Subbase Location
1/4" smaller than opening for the bit
and cutter.
Make sure that the bit and its cutter
are centered in the subbase opening.
If necessary, adjust the location of the
subbase as follows:
source before making any assembly,
adjustments
accessories. Such preventive safety
measures reduce the risk of starting
the tool accidentally.
Bosch routers are designed for speed,
accuracy
and
performing cabinet work, fluting,
beading, cove-cutting, rounding
edges, dovetailing, etc. They will
enable you to accomplish inlay work,
decorative edges and many types of
special routing.
Assembly
(A, Fig. 6).
To avoid pinching
injury, keep all parts
(E, Fig.
Cutter
diameter
must be at least
Operating Instructions
Disconnect the plug
from
the
power
or
changing
con venience
in
FIG. 8
1
3
1.
Loosen the three screws that hold
the subbase.
2.
Adjust the location of the subbase
as needed so that the bit and its
cutter are centered in the subbase
opening. The optional RA1151
centering device makes this easy.
3.
Tighten the three screws that hold
the subbase (Fig. 8).
When the subbase has been centered
in this manner, any part of the
subbase can be used as a guiding
surface without worrying about a
difference in the cut line. See
"Guiding The Router" on page 13.
Note: This subbase is not designed
for use with template guides. The
optional PR110 Attachment allows
use of template guides with this palm
router.
▶ Setting the Depth of Cut
Adjust the depth-of-cut only when the
motor is switched off.
1.
Install desired router bit.
2.
Place the router on the workpiece.
3.
Turn the clamping knob to the top,
unlocked position
4.
Slowly lower the motor until the
router bit touches the workpiece (
Fig. 9)
5.
Note the reading on the scale
(above the motor release button)
and add the desired depth-of-cut to
this value to determine the target
scale value.
11
2
(A, Fig. 9).
B
,
Publicité
Table des Matières
