Table des Matières
Publicité
8
Back Can S/PMK 8/PMK 6/PMK 3
Introduction
Thank you for purchasing this Accessory for TANNOY Dual Concentric In-Ceiling Loudspeakers for Installation Applications.
The Back Can S is an optional steel back can for the PCI and QCI in-ceiling loudspeakers.
The PMK 3 is an optional pre-mount kit for the QCI 3 in-ceiling loudspeakers.
The PMK 6 is an optional pre-mount kit for the PCI and QCI 6" in-ceiling loudspeakers.
The PMK 8 is an optional pre-mount kit for the PCI and QCI 8" in-ceiling loudspeakers.
The PMK 6 and PMK 8 kits can be used with or without the Back Can S.
The Back Can S can be used with or without the PMK 6 or PMK 8 kits.
Each accessory is available separately, and this quick start guide covers them all.
Unpacking
Every TANNOY product is carefully inspected before shipment. After unpacking, please inspect your product to ensure no damage has occurred in transit. In the
unlikely event of damage, please notify your dealer and retain all shipping materials as your dealer may require return shipment.
Safety Notices
TANNOY will not be held responsible for any damages caused by the improper installation of these loudspeaker accessories.
WARNING: This procedure requires the use of personal protection equipment, such as safety glasses and gloves.
WARNING: To avoid potential damage to your loudspeaker, ensure that the power amplifi er is switched OFF prior to connecting or disconnecting any cables.
WARNING: Make sure that there are no power lines, other cables, or plumbing such as water, sewer, gas lines in the chosen location.
Product Feature Identifi cation
PMK Pre-Mount Kit
PMK 3 is used for the QCI 3
PMK 6 (shown below) is used for the PCI and QCI 6" loudspeakers
PMK 8 is used for the PCI and QCI 8" loudspeakers
Frame
Mounting Brackets
Back Can S
Steel back can for PCI and QCI in-ceiling loudspeakers
Screw holes for
PMK kit option
Acoustic Foam
Mounting Slots (X10)
Quick Start Guide
Loop for strain
Cable Entry
relief of cable
9
Publicité
Table des Matières
