Publicité
Step 4
Secure Uuni 3 Gas Burner FSD
!
Parts required:
Assembled Uuni 3
with Uuni 3 Gas
Burner FSD
Allen key
Gas bottle
Secure but
do not over
tighten
bolts
10
USA / CAN
QCC1 gas regulator
This is a clockwise threaded gas
fitting. Ensure the tank is fully
turned off and screw the regulator
on to the gas tank valve fitting until
tight.
Gas Safety Information
•
The appliance must be installed at least 3.5ft (1 meter) from any flammable materials.
•
The oven should be placed on a non-flammable, stable and flat surface.
•
Make sure your oven is placed in an area that will not be affected by adverse weather.
•
When the diameter of the injector is 0.83mm use the provided 11 WC (28mbar) regulator
with Propane LPG cylinder.
•
An LPG cylinder shall be of a maximum nominal 20 lb (9.1 kg) fuel capacity.
•
Use a suitable provided regulator certified to ANSI Z21.18/CSA 6.3 and a flexible hose
certified to ANSI Z21.54/CSA 8.4.
•
The regulator shall be installed in such a location that it will not attain a temperature above
130°F (54.5°C)
•
The length of the hose must be no more than 2 ft (61cms). Worn or damaged hose must
be replaced. Ensure that the hose is not obstructed, kinked, or in contact with any part of
the oven other than at its connection.
•
The gas supply hose should be checked periodically and should be replaced if damaged
and at least every two years.
•
Check all connections for gas soundness.
•
Your country's national requirements will advise you how often to replace the hose. Regularly
review these requirements for your country.
•
In the case of blocked venturi immediately turn off burner unit, turn off gas supply,
disconnect gas supply and wait until cooled to removed from oven.
•
Ensure the appliance is clear of debris before every use. If any debris does build up use a
brush to remove this when appliance has cooled.
11
Publicité
