Télécharger Imprimer la page

Safety Information - Ooni UUNI 3 GAS BURNER FSD Manuel

Publicité

valve assembly supplied. Do not attempt to repair or alter the hose/valve/regulator for
any "assumed" defect. Any modification to this assembly will create the risk of a gas leak
and fire. Use only authorized replacement parts supplied by UUNI LIMITED. NEVER store
a spare LPG (propane) under or near your Uuni 3 oven or in an enclosed area. An LPG
(propane) not connected for use shall not be stored in the vicinity of your Uuni 3 oven or
any other appliance.
7.
You shall use your Uuni 3 Gas Burner FSD attachment part, in connection with your Uuni
3 oven, only with pre-bottled LPG (propane).
8.
Improperly stored LPG (propane) is a hazard due to possible gas release from the safety
relief valve. This could cause an intense fire with risk of property damage, serious injury
or death. If you see, smell or hear gas escaping, immediately move away from the LPG
(propane) tank/appliance and call your fire department.
UUNI LIMITED DOES NOT ACCEPT ANY RESPONSIBILITY, LEGAL OR OTHERWISE, FOR THE
INCIDENTAL OR CONSEQUENTIAL DAMAGE TO PROPERTY OR PERSONS RESULTING FROM
THE USE OF YOUR UUNI 3 GAS BURNER FSD ATTACHMENT PART WHICH DOES/DID NOT
COMPLY WITH ANY OF THE PROVISIONS OF THE PRESENT LEGAL DISCLAIMER.
UUNI LIMITED SHALL IN NO EVENT BE LIABLE FOR ANY SPECIAL, INDIRECT, CONSEQUENTIAL
OR OTHER DAMAGES OF ANY NATURE WHATSOEVER IN EXCESS OF THE ORIGINAL
PURCHASE PRICE OF YOUR UUNI 3 GAS BURNER FSD ATTACHMENT PART.
Some states or countries do not allow the exclusion or limitation of incidental or consequential
damages, therefore such limitations or exclusions may not apply to you.

Safety Information

Read instructions in their entirety before using appliance.
Only to be used outdoors.
WARNING: accessible parts may be very hot.
Keep away from young children.
Do not move appliance during use.
Ensure the gas supply is turned off at the cylinder after use.
Do not modify the appliance.
Parts sealed by the manufacturer or agent must not be manipulated by the user.
Always use protective gloves when handling hot components.
Storage of an appliance indoors is only permissible if the cylinder is disconnected and
2
removed from the appliance. When the appliance is not used for a period of time, it
should be removed from the oven and stored in its original packaging in a dry dust free
environment.
CAUTION: All cleaning and maintenance should be carried out when the oven is cool
and with the fuel supply turned OFF at the gas cylinder and disconnected.
BEFORE USE CHECK APPLIANCE AND CONNECTIONS FOR LEAKS:
Never check for leaks with a naked flame, always use a soapy water solution.
Leak testing: Leak test each time a new gas tank is connected or after a long period
without having used the appliance. Make sure that the valve is in correct alignment with
the venturi. Make sure that the hose has no cracking or splitting. IMPORTANT: if you
cannot stop a gas leak, turn off the gas tank valve and call your local gas tank dealer or
fire department.
The appliance must be kept away from any flammable materials during use.
When changing the gas canister, ensure that the Uuni 3 Gas Burner FSD knob is turned
to the off position, disconnect the regulator from the gas canister and remove the
canister. Throughout this process, ensure that the canister is kept a minimum of 1 meter
(3.5ft) away from the oven to avoid ignition risks.
Use 6 kg to 13 kg gas tanks with a maximum height including the regulator of 570mm
and a maximum diameter including the regulator of 310 mm. In case of smell of gas,
close the gas container tap and test the airtightness.
Regulator and Hose Requirements:
The regulator used with your gas burner oven must be CE approved, and conform to
local codes, such as EN16129. Also the hose connected to the tank must be approved
and conform to local codes. The length of the hose shall be no excess 1.5m (For Finland,
it should be no excess 1.2m)
If the ground temperature is above 50K, the surface needs protection.
Ø310mm
3

Publicité

loading