Instructions and notice for installation
The place which the unit is installed must be sturdy and able to withstand its weight. If not, it is
possible that the unit fall off and be destroyed.
The electrical system must comply with the local regulations and rating data in the technical
sheet, and the power supply must be separate.
If installed out of way, the unit can not run well and could be damaged.
Such as low voltage or the power type is wrong, it will raise unit electric leakage and burning.
The unit must effectively ground and connected reliably to the mains by wiring of adequate size.
If grounding is not well, it will arise fire or get an electric shock.
After the pipe systems was installed, they must be washed cleanly before connect with the units.
The pipe systems must be tested for compression resistance in order to check whether there is
any leakage.
It must be possible to leave room around the unit for air flow and any maintenance operations
that may be necessary.
The coagulation produced by unit can be removed easily.
Safety Cautions
Attention: It is not allowed that the water level is too low.
Don't restart the unit again and again; you must wait 5 minute to restart it.
If the water pump doesn't work, turn off it immediately.
Please cover the unit to keep out dust if no using for long time.
Please clean the evaporator by professional means timely .If the unit has worked for a long
time, there could be more dust in the evaporator coil, and the airflow volume will decrease.
To have a comfortable efficiency, don't set the temperature too high or too low.
Do not use unit near heater, fires or in the vicinity of flammable liquids and the place smeary.
Do not insert finger or others into place with a draught, it will do hurt to you.
Do not repair the unit yourself, please contact profession when the unit displays error code.
Do not spray flammable chemicals around unit to avoid fire.
15