Vasner StandLine 25R Mode D'emploi page 25

efficiently for a long time. In case there is a problem with your heater, please
contact your dealer.
• The cleanliness of the reflector (reflecting mirror) and tubes must be
checked at least once a month by the user. The cleaning and maintenance
instruction must be applied if dirty.
• According to the amount of dust in the place of use, the said checks should
be performed more often.
• Power cable and plug must be checked while cleaning the device. If there
is a deformation in the power cord or the plug, it must be taken to the
authorized service.
• Reflector, wire and body deformation must be visually inspected while
cleaning the device. If there is a deformation, authorized service must be
called for things to do.
Cleaning
Attention! Regular and careful cleaning performed by the user will ensure that
your device will run more efficiently and prolong its life.
• Your device must be turned off before starting to clean, its power cord
must be unplugged from the socket for safety and you must wait until it
cools down.
• If the reflector (reflecting mirror) and carbon filament tube is dirty, it must
be cleaned from the outside with dry air without opening the protective
cage wire of the device, if possible.
• The outer surface of the device must be cleaned with a soft cotton cloth or
a soft brush.
• Never use corrosive or melting liquids to clean the heater. These materials
may damage the plastic parts.
• Do not clean your device using vapor cleaners.
GB
VASNER
25