Vasner StandLine 25R Mode D'emploi page 23

Usage with remote control
1.
Installing and Replacing Remote Control Batteries:
As it can be seen, the tabs are pushed in the direction shown by the arrow, it is
simultaneously pulled in the direction shown by the arrow in the second figure
and the battery is replaced. A new battery is installed using the same method.
Only CR2025 batteries can be used.
The button is used for turning on and off the heater.
Heating level adjustment: shifts to power control mode. (+) and ( - )
buttons are used to make level adjustment between levels 0 and 4. The
alarm gives a signal for 0.2 seconds in every step and L1, L2, L3, L4, L0
appear.
Used to decrease the level, heat level, timing and thermostat values.
Used to increase the level, heat level, timing and thermostat values.
Thermostat button: shifts to heat adjustment mode. (+) and ( - ) buttons
are used to make heat adjustment between 10 and 40 degrees. The
thermostat button must be pressed to save the adjusted heat. It is
enough to press this button once for the user to see the adjusted heat.
The device never switches off the heating completely!
Timer-button: It shifts to the timing mode by flashing on the screen and
timing up to 9 hours is carried out with (+) and ( - ) buttons. After the
timing is done, the timer button is pressed again to save. It is enough to
press this button once for the user to see how much time is left.
0H, 1H, ...9H appears on the screen.
2.
GB
VASNER
23