Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Locking the device onto the hanging frame
5/
6/ Maintenance
To maintain the performance of the device, the upper and lower grills
must be cleaned with a vacuum clener or a brush approximately twice
per year. Do not use abrasive products.
You can run your device in several modes:
• Comfort mode which enables you to have the right ambient temperature.
• Eco mode which enables you to lower the temperature in your room when you will be away from your home for a
long time
• Programming mode which enables you to programme the Comfort and Eco modes according to how a room
will be occupied

Control box

13
Setting the comfort temperature
This is the temperature desired when the room is occupied.
Set cursor A to position
Adjust knob B to 5. The heating indicator V1 will illuminate if the tem-
perature is below the desired temperature .
Wait a few hours for the temperature to stabilise.
When you are happy with the setting (you may wish to use a thermome-
ter to check), mark the position once and for all. If you are not happy
with the setting, re-adjust it and proceed again .
Setting the Eco temperature
This involves a reduction in degrees compared to the Comfort temperature. We recommend that you use this
mode for periods of absence of more than 2 hours or overnight.
Set switch A to
. The device is now in Eco mode (Comfort temperature minus approx. 3°C to 4°C).
Programming mode
The device is fitted with a thermostat that can be controlled via the control wire. It recognises the following com-
mands:
Ordre
Abaissement
ECO
-3,5°C
HORS GEL
Ambient temperature maintained at around 7°C.
Stopping the heating immediately (used for power
ARRET
cutoff).
Operation
V1
A
B
Use
, the indicator V1 lights.
PROG
13
Heating light indicator
Mode cursor
Temperature adjustment control knob.
NB: If no commands are received via the control
wire, the device operates in Comfort mode.The
frost-free and power interruption commands are
prioritised over the Eco and Comfort modes.
When switching from Comfort to Eco mode, the
switchover time is around 12 seconds.
11
12
10
9
GB

Publicité

Table des Matières
loading

Table des Matières