Travel Buggy DASH Ultra Lite Power Wheelchair Mode D'emploi page 5

G E T TI N G STAR T E D
*CLICK*
ASSEMBLY
• Unfold the power wheelchair until there is a "CLICK" indicating it is in the fully extended and
locked seating position
• Attach the joystick controller by first locating the joystick attachment and loosely fastening it
into place
• Insert joystick controller to desired length and fasten tight with the corkscrew knob. Note, the
joystick length can be adjusted as required. Loop the joystick cable into the designated cable
holder on the side of the power wheelchair
NOTICE: the Joystick Controller can be attached on the left or right side as preferred. Simply move the joystick
attachment to the alternative side as desired.
8
G E T TI N G STAR T E D
• Locate the smaller cushion of the two,
the back rest cushion "I", and adhere to
Velcro at the bottom and around the
top of the back rest. Widest part of the
backrest cushion should be at the top of
the back rest
• Next attach the seat cushion "H". Be
sure to fold the seat cushion under the
front of the seat to secure it in place.
The widest part of the seat cushion is
nearest to the front of the chair.
9